US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual de usuario descargar pdf (Pagina 51)

56K Softmodem

Command Reference

- 45

Table 3-79: +ESR Parameter Values

Table 3-80: +ESR Extended Syntax Commands

Note:* Refer to ITU- T recommendation V.42 for a complete definition of the selective reject mode.

+ETBM=<pending_TD>,<pending_RD>,<timer>—Call Termination Buffer Manage-

ment

Use this command to set the behavior of the modem during call termination. The

<pending_TD> parameter controls how previously transmitted data remaining in

the DCE buffers is handled when the DTE request a disconnect from the call. The

<pending_RD> parameter controls how previously received data remaining in the

DCE buffers is handled when the remote DCE disconnects the call. The <timer>

parameter sets the maximum amount of time the 56K Softmodem will attempt to

deliver the buffered data before abandoning the attempt and discarding any

remaining data.

Result codes:

OK if <pending_TD> = 0—2 and <pending RD> = 0—2 and <timer> = 0—254.

ERROR if <pending_TD> does not equal 0—2 or <pending RD> does not equal

0—2 or <timer> does not equal 0—254.

Command Description

0 Enables the selective reject mode.

1 Disables the selective reject mode.

Command Description

+ESR=<value> Turns on or turns off the selective reject mode.

+ESR? Displays the current settings for the selective reject mode.

+ESR=? Displays the supported settings for the selective reject mode.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 107 108

Sin comentarios

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual de usuario Pagina 51