US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual de usuario descargar pdf (Pagina 36)

56K Softmodem

Command Reference

- 30

Table 3-41: \R<value> Commands

\T<time delay>—Inactivity Timer

Use this command to specify the delay time used by the inactivity timer. The delay

time is the length of time in minutes that the modem waits during periods of

inactivity before disconnecting. Periods of inactivity are defined by no data being

sent or received by the DCE. To disable the inactivity timer, use the T0 command.

The delay time may also be specified in register S30 (see “S30—Inactivity Timer”

on page 89).

This function is only applicable in buffer mode.

Result codes:

OK if <time delay> = 0—255.

ERROR if <time delay> does not equal 0—255.

Table 3-42: \T<value> Commands

\V<value>—Protocol Result Code

Use this command to enable or disable protocol result codes. Result codes:

OK if <value> = 0—2.

ERROR if <value> does not equal 0—2.

Table 3-43: \V<value> Commands

%B—View Numbers in Blacklist

If blacklisting is in effect, this command displays the numbers that are currently

Command Functions

\R0 Ring indicator is off after the telephone call is answered.

Command Function

\T0 Inactivity timer disabled (default).

\T1—\T255 Specifies the length of time in minutes that the modem will wait

before disconnecting when no data is sent or received.

Command Function

\V0 Disables protocol result code appended to DCE speed.

\V1 Enables protocol result code appended to DCE speed (default).

\V2 Enables protocol result code appended to DCE speed (same as \V1).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 107 108

Sin comentarios

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual de usuario Pagina 36