US Robotics NETServer/8 Manual de usuario descargar pdf (Pagina 34)

2-6 Basic Installation and Setup

The NETServer routing engine is a completely separate device

from any of the I-modems. Its job is to route data from its ports (all

B-channels of all internal I-modems) to its LAN (Ethernet)

interface and vice versa. However, it is also able to configure and

use the internal I-modems to establish connections with remote

devices. See Figure 3 below.

Figure 3. Conceptual view of the NETServer/8 I-modem

Ordering ISDN Service

Although efforts are being made to simplify ISDN ordering, it

can still be a complex process. This section should give you and

your local telephone company all the information you need to

set up your ISDN lines correctly. Here’s what to do:

Call your local telephone company to request your ISDN

lines. Explain NETServer 8/16 Plus requirements as

described in this section.

Your local telephone company will give you information

about your lines and settings.

Program the line’s settings into your NETServer’s internal I-

modems.

If, after looking over this chapter, you decide you would

like assistance with the ordering process, call the U. S.

Robotics I-Team at (800) 550-7800.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 300 301

Sin comentarios

US Robotics NETServer/8 Manual de usuario Pagina 34