US Robotics NETServer/8 Manual de usuario descargar pdf (Pagina 137)

LAN-to-LAN Routing 7-11

Step 4 - Set the Remote Device Phone Number

Specify the remote device's phone number using the following

command:

set user

<name>

phone_number

You can also specify an alternate phone number that the

NETServer will dial if it cannot connect using the primary

phone number. Use the following command:

set user

<name>

alternate_phone_number

Step 5 - Configure Dial-Out Parameters

Dial-out parameters determine how the NETServer will initiate

and handle the dial-out connection to the remote router. Use

the following command:

set dial_out user

<name>

site type

[on_demand | timed | manual | continuous]

start_time

<time>

end_time

<time>

modem_group

<name>

idle_timeout

Type

Determines when the NETServer will dial out to the remote

device. The default is manual.

On Demand The NETServer dials out to the remote device

when it has packets queued for that location. It

then maintains the connection only as long as

there is traffic on the line. Note that dynamic

routing information is updated while there is a

connection between the two devices, but not

before the NETServer dials or after it hangs up.

Timed The NETServer dials out at times of the day that

you specify. See the start time and end time

parameters for more information.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 300 301

Sin comentarios

US Robotics NETServer/8 Manual de usuario Pagina 137