US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Manual de usuario Pagina 96

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 158
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 95
USRobotics
Command Reference
Data Command Set - 88
-QCPC - Force Full Startup Procedure Next Connection
This command causes the modem to use full startup procedures on the next
connection attempt regardless of the setting of the +PQC command. After this
attempt, the modem will select the startup procedure as defined by the +PQC
command. If a shortened startup procedure is enabled by the +PQC command,
then the quick connect profile will also be updated on the next connection attempt.
Syntax
-QCPC
Result Code
OK In V.92 Mode (+MS=V.92)
ERROR Otherwise
-QCPS - Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick
connect profile.
Syntax
-QCPS=<value>
Defined Values
<value> Decimal number corresponding to the desired operation. 0 Do not
allow the quick connect profile to be saved. 1 Allow the quick
connect profile to be saved. (Default.)
Result Codes
OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is enabled
(+PSS = 0)
ERROR Otherwise
Reporting Selected Value(s)
Command: -QCPS?
Response: -QCPS: <value>
Example: -QCPS: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: -QCPS=?
Response: -QCPS: (<value> range)
Vista de pagina 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 157 158

Comentarios a estos manuales

Sin comentarios