US Robotics USR8700 Guía de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 156
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Serial ATA 4-Drive NAS
User Guide
Getting Started - 14
2. Near the front of the tray is a spacer containing four screws. Squeeze the tabs toward each other to
remove the spacer from the tray.
3. With the flat edge of the spacer up and the screws facing a flat surface (such as a table or desk top),
flex the sides of the spacer apart from each other to release the screws.
4. Make sure that the hard disk is a SATA disk. It should have a SATA connector similar to the following:
5. Slide the new hard disk into the tray (connector end down and toward the back of the tray), and fasten
the screws on the sides of the tray:
6. Slide the hard disk and tray back into the storage system until it snaps into place.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 155 156

Comentarios a estos manuales

Sin comentarios