US Robotics USR2410 Manual de usuario descargar pdf (Pagina 87)

}

else

{

print("Can't figure out click configuration parameters (didn't try too hard)\n");

sleep (2);

system($BEEP_FAILURE);

}

$date = `date`;

print ("Finished meshstart: $date\n") ;

Meshstart.conf

#----------------------------------------------------------------------#

# Define beeps #

# ---------------------------------------------------------------------#

$BEEP_STARTUP = "beep -f 1200;beep -f 1300;beep -f 1500;beep -f 1700";

$BEEP_FAILURE = "beep -f 1000 -l 300;beep -f 100 -l 700";

$BEEP_MESH_SETUP = "beep -f 600;";

$BEEP_CLIENT_SETUP = "beep -f 1000;beep -f 1000";

$BEEP_NETWORKCARD_SETUP = "beep -f 1200;beep -f 1200;beep -f 1200";

$BEEP_CLICK_START = "beep -f 400 -l 300;beep -f 700;beep -f 1200 -l 300;beep -f 700; beep

-f 400 -l 300";

#----------------------------------------------------------------------#

# Define Mesh Interface #

# ---------------------------------------------------------------------#

$MESH_CHANNEL = "30";

$MESH_ESSID = "meshnet";

$MESH_DEV = "ath0";

$MESH_DEVICE_ADDR = "10.0.0.3";

$MESH_NETMASK = "255.255.255.0";

# Use this value if using an atheros device for the mesh

$ATH_WIFI_DEV = "wifi0";

#----------------------------------------------------------------------#

# Define Client Interface #

# ---------------------------------------------------------------------#

#$CLIENT_CHANNEL = "11";

#$CLIENT_ESSID = "clientnet";

$CLIENT_DEV = "eth0";

$CLIENT_DEVICE_ADDR = "11.0.0.3";

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 106 107

Sin comentarios

US Robotics USR2410 Manual de usuario Pagina 87